Warrior
Home Page > Warrior Products > Sideplates & Rear Corners

Sideplates & Rear Corners by Warrior Products

1987-1995 Jeep Wrangler YJ


Rear Corners have a material thickness of 1/8", and not only provide structural support to the corner area, but enhance the appearance of your Jeep Wrangler YJ also. To allow easier installation, corners have precut holes for the gas tank and tail light openings. Available in four exterior finishes, these corners are long lasting and durable. Sold in pairs. Note: Rear corners will not fit Renegade and/or Sahara Wrangler trim packages, nor Aftermarket fiberglass bodies.



Back to Top


Back to Top


Rear Corners With LED Cutouts have openings to accommodate two flush-mounted LEDs: a 4" red stop, turn and taillight, plus a 2" white reverse light. All lights are American-made with a lifetime warranty, and are sold separately. As expected, the corners also have a cutout for the gas tank. Available in four finishes. Sold in pairs.



Back to Top


LED Light Kits. Replace your Jeep Wrangler tail lamps with these LED Light Kits. All lights are American-made with a lifetime warranty. Load Resistor Kit. Due to its lower power consumption, LED bulbs may cause some vehicles to indicate a bulb is burnt out. Fix this with load resistors wired across the LED bulbs to simulate a filament bulb load.



Back to Top


Sideplates protect the rocker panel area below the door and enhance the appearance of the vehicle too. Available flat or with a 90-degree bend (lip) that wraps under the rocker panel 1", Sideplates are sold in pairs. Notes: Sideplates will not fit Renegade and/or Sahara Wrangler trim packages, nor Aftermarket fiberglass bodies. In addition, Sideplates can be ordered without its front section cutout by placing an “X" behind the part number; i.e. #913X. The front edge must then be cut to fit any fender well treatment.



Back to Top


Back to Top


Back to Top


Back to Top

 
  Loading...