Rear Corners have a material thickness of 1/8”, and not only provide structural support to the corner area, but enhance the appearance of the vehicle too. To allow easier installation, corners have precut holes for the gas tank and tail light openings. Available in four exterior finishes, these corners are long lasting and durable. Sold in pairs. Note: Rear corners will not fit Renegade and/or Sahara Wrangler trim packages, nor Aftermarket fiberglass bodies.
Corners Without Holes
Part #: WAR916
Diamond Plate
Price: $93.52
Part #: WAR916PC
Powder Coated Diamond Plate
Price: $123.50
Part #: WAR916PA
Polished Aluminum
Price: $332.99
Part #: WARS916
12-gauge Steel
Price: $110.78
Corners With Holes
Part #: WAR916A
Diamond Plate
Price: $109.99
Part #: WAR916APC
Powder Coated Diamond Plate
Price: $136.99
Part #: WARS916A
12-gauge Steel
Price: $171.99
Corners For Bushwacker Flares With Holes
Part #: WAR916AX
Diamond Plate
Price: $103.96
Part #: WAR916AXPC
Powder Coated Diamond Plate
Price: $137.59
Part #: WARS916AX
12-gauge Steel
Price: $127.99
Sideplates protect the rocker panel area below the door and enhance the appearance of the vehicle too. Available flat or with a 90-degree bend (lip) that wraps under the rocker panel 1”, Sideplates are sold in pairs. Notes: Sideplates will not fit Renegade and/or Sahara Wrangler trim packages, nor Aftermarket fiberglass bodies. In addition, Sideplates can be ordered without its front section cutout by placing an “X” behind the part number; i.e. #913X. The front edge must then be cut to fit any fender well treatment.
