Sideplates & Rear Corners by Warrior Products

Rear Corners have a material thickness of 1/8”, and not only provide structural support to the corner area, but enhance the appearance of the vehicle too. To allow easier installation, corners have precut holes for the gas tank and tail light openings. Available in four exterior finishes, these corners are long lasting and durable. Sold in pairs. Note: Rear corners will not fit Renegade and/or Sahara Wrangler trim packages, nor Aftermarket fiberglass bodies.

Rear Corners w/LED Cutouts have openings to accommodate two flush-mounted LEDs: a 4” red stop, turn and taillight, plus a 2” white reverse light. All lights are American-made with a lifetime warranty, and are sold separately. As expected, the corners also have a cutout for the gas tank. Available in four finishes. Sold in pairs.

Jeep Wrangler JK 2 Door

Part #: WAR924A		Diamond Plate	Price: $89.99	Click for More Information
Part #: WAR924APC		Powder Coated Diamond Plate	Price: $144.99	Click for More Information
Part #: WAR924APA		Polished Aluminum	Price: $249.99	Click for More Information
Part #: WARS924A		12-gauge Steel	Price: $109.99	Click for More Information

Jeep Wrangler JK Unlimited 4 Door

Part #: WAR926A		Diamond Plate	Price: $129.99	Click for More Information
Part #: WAR926APC		Powder Coated Diamond Plate	Price: $149.99	Click for More Information
Part #: WAR926APA		Polished Aluminum	Price: $279.99	Click for More Information
Part #: WARS926A		12-gauge Steel	Price: $129.99	Click for More Information

LED Light Kits. Replace your Jeep Wrangler tail lamps with these LED Light Kits. All lights are American-made with a lifetime warranty.
Load Resistor Kit. Due to its lower power consumption, LED bulbs may cause some vehicles to indicate a bulb is burnt out. Fix this with load resistors wired across the LED bulbs to simulate a filament bulb load.

Sideplates protect the rocker panel area below the door and enhance the appearance of the vehicle too. Available flat or with a 90-degree bend (lip) that wraps under the rocker panel 1”, Sideplates are sold in pairs. Notes: Sideplates will not fit Renegade and/or Sahara Wrangler trim packages, nor Aftermarket fiberglass bodies. In addition, Sideplates can be ordered without its front section cutout by placing an “X” behind the part number; i.e. #913X. The front edge must then be cut to fit any fender well treatment.

Jeep Wrangler JK 2 Door

Part #: WAR921		Diamond Plate 2"	Price: $109.99	Click for More Information
Part #: WAR921E		Diamond Plate 5" With Lower Facotry Door	Price: $169.99	Click for More Information

Jeep Wrangler JK Unlimited 4 Door

Part #: WAR922		Diamond Plate 2"	Price: $109.99	Click for More Information
Part #: WAR922E		Diamond Plate 5" With Lower Facotry Door	Price: $169.99	Click for More Information