Wiring Harness Kit- Painless Performance- Complete Kit

1976-1986 JEEP CJ Uses the factory-style bulkhead connector so no special brackets are required. Almost every circuit on this harness is pre-terminated at both ends on this three section harness. All wires are color coded and labeled and all wire leads are pre-cut to proper lengths. Our harness uses an OEM style bulkhead connector that attaches to the bulkhead without any special brackets or modifications. The blade-type fuse block wiring is factory terminated and machine crimped. The most Painless way to wire your 76-86 CJ Series Jeep. NOTE: This harness is fully grounded for use with fiberglass Jeep bodies. Engine Section: Chassis ground, brake failure warning switch, horn, windshield washer, heater motor, park and signal lights, front marker light (w/bulb socket), headlights, sending units, starting, charging, ignition circuits, tachometer lead, ballast resistor, maxi fuse, terminal ends, wire ties and grommets. Rear Section: Main harness-to-rear harness, rear marker lights (with bulb sockets), rear lamp ground and tail light housing (4 wire). Main Body Section: Heavy duty blade style ATO fuse block, heater switch, blower motor resistor, dimmer switch, ignition switch, turn signals, headlight switch, windshield wiper power, turn signal indicators (with bulb socket), high beam indicator (with bulb socket), dome lamp ground and power, neutral safety switch, stop light switch, dash indicator lamps, backup lamp switch, water temp gauge (with illumination sockets), oil pressure gauge (with illumination sockets), fuses, flashers, horn relay and emergency brake switch. ear harness, rear marker lights (with bulb sockets), rear lamp ground and tail light housing (4 wire).