Skyjacker™ Suspension Accessories

Sold Separately!
ROCK READY ROLL BAR GRAB HANDLES 2 &3 inches(PAIR), BY SKYJACKER FITS ALL JEEPS. Skyjacker Grab Handles will give you the grip to hang on tight through sharp turns and tough terrain! These high quality grab handle pieces are tested throughly by Skyjacker for look and functionality. Skyjacker Grab Handles are made to fit on 2" and 3" Roll Bars and come in black or red.

Fitted Rear Add-A-Leaf (Pair)
Sold Separately!

Skyjacker’s fitted leafs have got you covered. These add-a-leafs will turn your regular lifted leaf spring pack into a heavy-duty lifted spring pack. Skyjacker’s fitted leafs strengthen the load capacity of your lifting leaf springs, but are not designed to give additional lift.

Dropped Pitman Arm
Sold Separately!

A dropped pitman is designed to compensate for a vehicle's suspension lift to help maintain the factory feel at the steering wheel by eliminating "bump steer" and any potential interference with the steering components and the vehicle's chassis.

Dropped Pitman Arm
Sold Separately!

When lifting a vehicle more than a couple of inches, it is necessary to use a dropped pitman arm to lower the steering rod and improve geometry of the linkage. These Skyjacker pitman arms prevent bump steer caused by tall lift kits.

Transfer Case Lowering Kit
Sold Separately!

Transfer case lowering kits allow enthusiasts to gain height without sacrificing the driveshaft. They help eliminate drivetrain angle problems and annoying driveline vibration. Restore your driveshaft angle to its original specification on vehicles equipped with suspension lifts.

Sway Bar Quick Disconnect End Link
Sold Separately!

For the best sway bars available today, check out Skyjacker, the Bear of Suspensions! These top-quality accessories for your Jeep CJ increase the suspension’s roll stiffness. Both have extended end links and double disconnects. For sway bars that truly last a long time, check these out below from Skyjacker.

Tie Rod, 1.25 Inch. HD Dom Swedged Tubular Replacement

These heavy duty replacement steering tubes are made from 1.250” D.O.M. swegded tubing. They fit the factory ends and allow for maximum articulation. No more bending; the strongest tubes available anywhere!

Tie Rod, 1.25 Inch. HD Dom Swedged Tubular Replacement

SJ-TR100

CV Yoke, Front or Rear, Skyjacker

The Skyjacker CV Yoke Kit allows lifted CJs, equipped with Dana 300 transfer cases, to install a double Cardan constant velocity rear driveshaft which will eliminate the need to lower the transfer case and sacrifice ground clearance.

CV Yoke, Front or Rear, Skyjacker

SJ-CV300

Tie Bolts 3/8 Inch, X 3 Inch Length, Rear, Skyjacker, Pair

Skyjacker Rear Tie Rod Bolts For Your Jeep CJ and Jeep Wrangler YJ. 3/8" by 3" In Length.

Tie Bolts 3/8 Inch, X 3 Inch Length, Rear, Skyjacker, Pair

SJ-3803

Spacer Plate, Spring, Wide Leaf Spring, 2.5 Inch, Skyjacker

This spacer plate fits any & all 2.5" To 3" wide leaf springs on top of rear axle

Spacer Plate, Spring, Wide Leaf Spring, 2.5 Inch, Skyjacker

SJ-SP1225

Bump Stop Bracket, Front/Rear, 3 Inch, Mount On Axle

This bump stop bracket is not a polyurethane bump stop. They are bump stop brackets that mount on the Axle. Prevent damage to your springs.

Bump Stop Bracket, Front/Rear, 3 Inch, Mount On Axle

SJ-BP30

Sway Bar Bushing Kit, Front, Skyjacker

Skyjacker's sway bar bushing kit is made of polyurethane. Polyurethane is a superior material that has a higher load bearing capacity and can better resist the dynamic torque, like twisting and turning forces of suspension components as they go through their normal operation & travel movements.

Sway Bar Bushing Kit, Front, Skyjacker

SJ-JSB15

Swaybar Lowering Kit, Front, Skyjacker

New springs and steering linkage can get in the way of your sway bars. This Sway Bar Lowering Kit realigns the working angle for maximum sway and body-roll control by dropping the mounting brackets down a few inches. This Sway Bar Lowering Kit mounts to the existing factory-drilled frame holes.

Swaybar Lowering Kit, Front, Skyjacker

SJ-SBL20