Jeep Ignition Parts for Wrangler TJ

Distributor Caps for Wrangler TJ

When you Jeep Wrangler TJ Ingnition system begins to foul up, it becomes necessary to replace worn ignition system parts, the Distributor Cap is one of those parts that can be the cause of mis-firing, poor performance, lack of power, among other issues. Also it is good to replace your Rotor as well.

Distributor Gear for Wrangler TJ

Replace your worn or damaged Distributor Gear for you Jeep Wrangler TJ, using quality, factory OEM replacement parts.

Rotor for Wrangler TJ

Over time your Distributor Rotor can get worn down and or corroded, replace your Jeep Wrangler TJ Rotor when performing a tune-up to maintain optimal performance and fuel economy.

Ignition Switch for Wrangler TJ

The Igntion Lock Switch on your Wrangler TJ over time can wear out and loose connection. We have replacement switches that are quality, factory OEM replacement parts to keep your Wrangler TJ Ignition System opperating flawlessly.

Distributor Switch Plate for Wrangler TJ

Replace your Distributor Switch Plate on your Wrangler TJ with a quality, OEM replacement part when performing a full tune-up on your TJ to ensure optimal performance and efficiency.

Distributor Assembly for Wrangler TJ

For a complete rebuild of your Wrangler TJ Ignition System your Distributor is an integral part of your engine's performance, replace it with a quality, factory OEM replacement part to be sure to have years of solid dependability.

Ignition Coil for Wrangler TJ

An ignition coil (also called a spark coil) is an induction coil in an automobile's ignition system which transforms the battery's 12 volts (6 volts in some older vehicles) to the thousands of volts needed to spark the spark plugs.

Ignition Coil Pack for Wrangler TJ

An ignition coil (also called a spark coil) is an induction coil in an automobile's ignition system which transforms the battery's 12 volts (6 volts in some older vehicles) to the thousands of volts needed to spark the spark plugs.

Sparks Plugs for Wrangler TJ

A spark plug is an electrical device that fits into the cylinder head of your Jeep's engine and ignites compressed gasoline by means of an electric spark.

Ignition Wires for Wrangler TJ

Spark plug wires should be replaced any time it exhibits physical damage either to the ignition wire or the boots - this includes a cut, grooves or marks from chafing or marks from being burnt. If moisture builds between the spark plug and the ignition wire or in the spark plug hole, it can cause arcing. This will cause damage to the spark plug wires and possibly the spark plug as well. Make sure to keep wires in areas without excessive heat as it can damage the silicone insulation.

Crankshaft Position Sensor for Wrangler TJ

To record the rate at which the crankshaft is spinning, you will need a Crankshaft Position Sensor.

Complete Tune-Up Kits

We have Complete Tune-up Kits for your Wrangler TJ, get everything you need to do a full tune-up and save.

Camshaft Synchronizer for Wrangler TJ

Camshaft synchronizers are devices that are driven off camshafts to tell the powertrain computers exactly what point of rotation the camshaft is currently located. Then that information is used by the powertrain computer to time the spark that ignites the mixture of fuel and air inside the cylinders.